In the picture you’ll see the drawer side on the left and the frame piece on the right.Īll that was left was assembly. Because a perfect fitting slide would actually be too tight for a drawer, the groove on the drawer side was cut slightly wider by 1/32″ to allow for smooth travel now and in the future. A similar groove is cut into the drawer side. Wooden drawer runners were installed without the need for screws by gluing the runner stock into a groove that runs down the length of the framework. None of the joints for this part were particularly interesting, consisting of simple dados, rabbets and grooves. The frame not only supports the drawer but also provides extra support on the left side of the case, a job previously done by our new drawer front. With the drawer parts cut to size, I began working on the frame. Using the router, I created both the male and female parts of the joint. Since the drawer front is a pre-existing piece from the project, I needed to come up with a strong joint that wouldn’t change the look on the outside face or require making a new part. Here are some of the highlights from the hidden drawer build. I quickly hopped into SketchUp and made it happen, virtually anyway. Thankfully, my buddy Aaron offered the perfect solution: use an entire side base piece as the drawer front. ![]() My initial thought was to have a drawer placed in the back which would result in an obvious “drawer” to anyone who inspects the rear of the case. ![]() I thought it over for a while and decided that a hidden drawer would be a fun alternative to more drastic solutions that might modify the look to some degree. It was pretty clear from the start that lots of folks wanted to redesign the piece slightly to recover some of that lost space. So in essence, there’s a lot of wasted space under this bad boy.Įven though I provide a finished plan for Guild members to build from, everyone is encouraged to make modifications that suit their needs and tastes. The reason for this is the fact that the case is propped up on a substantial base consisting of a deck and a finger jointed frame. As designed, the interior of the chest only has 13 1/2″ in depth even though the entire piece stands at about 20″. Right now in the Wood Whisperer Guild, we’re building a Greene & Greene Blanket Chest.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |